Find Verified Induction Heaters Suppliers, Manufacturers and Wholesalers

D6 Virgin Fuel Oil (often called D6 Virgin Oil, D6 Fuel Oil, or Residual Fuel Oil D6) is a heavy residual fuel obtained directly from the refining process and has not been previously used or reprocessed.

D6 virgin fuel = Bunker C, or Navy Special Fuel Oil.

It's the heavy, bottom-of-the-barrel fuel left after gasoline, diesel, jet fuel, etc. are distilled out of crude oil. Virgin just means it's straight from the refinery, not recycled/blended waste oil.

KEY SPECS:

Type: Heavy, high-viscosity residual fuel oil
Grade: Category 6 fuel oil - thickest grade
Viscosity: 650-900 cst @ 50C - like tar at room temp
Color: Black, dense
Energy: ~150,000 BTU/gallon - very high energy density
Sulfur: High, typically <3.5%. Low-sulfur versions exist but cost more
Flash point: Min 60C

Key Characteristics.
Fuel Type: Residual Fuel Oil
Appearance: Dark brown to black
Viscosity: Very high
Density: Higher than diesel
Heating Requirement: Usually required
Main Use: Industrial and marine fuel

D6 is a heavy fuel oil (HFO) primarily used for:
Power plants
Marine vessels (where regulations permit)
Large industrial boilers
Heavy industrial furnaces

1. Power plants - Boilers & turbines for electricity, often backup fuel
2. Large ships - Ocean tankers, bulk carriers, container ships as bunker fuel
3. Industrial - Cement plants, steel mills, big boilers/furnaces for process heat
4. Large generators - Backup power for factories/grid.

*Important: Special handling needed*
D6 is so thick/viscous it must be *pre-heated to 104-127C* before it can be pumped or burned. You need special storage tanks, heaters, and burners.

*Not for cars, small boats, or normal diesel engines*. It will destroy them. D2 diesel is much lighter and for trucks/cars - D6 is only for massive engines designed for it.

Cost vs Environment:
- Pros: Cheap per energy unit, high BTU, cost-effective for bulk use
- Cons: One of the most polluting fuels due to high sulfur + impurities SO2, acid rain. Regulations now require desulfurization.

D6 vs D2 diesel: D2 = light distillate for cars/trucks. D6 = heavy residual for ships/power plants. D6 has way more energy but also way more pollution and handling complexity.

It is much thicker and heavier than diesel or Jet A-1 and usually requires heating before it can be pumped or burned.

collection of urban lighting units provided with many patterns and independent intellectual properties and many advanced technologies.

Lighting poles range are designed to give spread light distribution which makes this luminaire suitable for gardens, path ways and homes.

Lighting poles range are designed to give spread light distribution which makes this luminaire suitable for gardens, path ways and homes.

Bollards from the outdoor range , come with fabulous designs and different ranges.
IP 65
free standing luminaire
ideal for lighting path ways and gardens
available in different lengths
extremely durable.

E-sign is a series to comply building fire codes an insurance standards.
it uses less than 2 watts of power with back up battery for 3 hours.

Flood light luminaire in an elegant design is making the installation flexible and convenient, it does not only provide bright and lasting lighting but also reduce maintenance.
material: made of die cast Aluminum treated and painted with electrostatic powder coating
Lens: made of safety and tempered glass
Suspension: surface mounted

Step Light: recessed mounted step light . provide beauty durability and performance , with no visible fasteners to provide seamless integration with architectural styles.
Ground Recessed Luminaire: range of inground up lights with different shapes.

H-Bay is a Lighting luminaire designed to produce optimum illumination while providing specific light patterns for specific applications.

creating pleasant spaces that are well lit in a soft and gentle way with uniform surface of light.

Indoor range

Add a decorative dimension to your interior architecture. using Die -Cast aluminium housing with the most efficient optical solutions and latest LED and driver technology.
our range includes:
-Downlights
-Task Lighting
-Surface mounted

Capacity: 80 (Lt.)
Diameter * Height: 460*750 (mm)
Voltage: 220 (volt.)
Heating power: 2000 (Watt)
Current: 9.1 (Amp.)
Working Pressure: Maximum 70 (N/Cm¦)
Weight: 25.5 (KG)
Heating Time: 100 (Min.) at 55 ¦C



We load 300 appliance in 40'HC.

Capacity: 100 (Lt.)
Diameter * Height: 460*940 (mm)
Voltage: 220 (volt.)
Heating power: 3000 (Watt)
Current: 13.6 (Amp.)
Working Pressure: Maximum 70 (N/Cm¦)
Weight: 31 (KG)
Heating Time: 85 (Min.) at 55 ¦C


We load 200 appliance in 40'HC

Capacity: 40 (Lt.)
Diameter * Height: 460*450 (mm)
Voltage: 220 (volt.)
Heating power: 1200 (Watt)
Current: 5.4 (Amp.)
Working Pressure: Maximum 70 (N/Cm¦)
Weight: 18 (KG)
Heating Time: 75 (Min.) at 55 ¦C

We load 500 appliance in 40' HC

From 10 liter till 150 liter

Electric Water Heaters for home use storage & heating Water

We Are Suppliers Of High Quality Yamaaha Outboard Engines Both Used And New. We Have A Wide Range Of 350HP, 300HP, 250HP, 200HP, 150HP, 100HP 75HP, 60HP 40HP AND MORE

EXTREME OFFSHORE PERFORMANCE AND DURABILITYâ??NOT TO MENTION STRIKING GOOD LOOKS.
The all-new four-stroke, 5.6L V8 425 hp XTO Offshore is more than an outboard. Itâ??s an integrated power system. Coursing with insightful engineering and industry-first technology such as an electric steering system, itâ??s revolutionizing offshore
boatingâ??and the ownership experienceâ??for yacht-class boaters.

Our integrated digital boat control system now features Set Point. This suite of satellite-guided boat control functions
automatically maintains your position, heading or both. Suddenly fishing beneath the boat, controlled drifting and waiting in place are a snap for captains of any skill level.

SPECIFICATION:
Model Code 2: F40BEDL/ F40BETL
Engine: 4 stroke, SOHC, In-line 3
Displacement: 747 cm�³
Compression Ratio: 9.4
Max. Prop Shaft Output: 29.4 kW (40 ps) @ 5500 r/m
Full throttle rpm range: 5000 ~ 6000 r/m
Fuel Induction System: Electronic fuel injection
Starter System: Prime Start
Lubrication: Wet sump
Engine oil capacity: 1.7 l / 1.5 l * with/ without oil filter exchange
Bore x Stroke (mm): 65.0 mm x 75.0 mm
Fuel consumption: 13.6 l/h @ 5500 r/m
Trim & Tilt: Hydro (5-steps)
Shallow Water Drive Positions: (continuously variable)
Gear ratio: 2.0 (26/13)
Engine transom height: L: 536 mm (21.1
Dry Weight: 100 kg

Capacity: 24, 45, 60, 80 LITERS CLASS B

-An automatic high pressure rapid sterilizer which works with steam as medium.
-Can be widely used in department of stomatology and ophthalmology, operating room, CSSD.
-Suitable for all (un)wrapped solid instruments, A-class cavity instrument (Dental hand piece), implantable instruments, dressing fabric and rubber tubes, etc.
-Stainless steel 304 chamber structure: cylinder, horizontal, single door.
-Door opening method: automatic, press button.
-High efficient WJS (water ejector) vacuum system, which supply high speed vacuum and low working noisy, vacuum lower limit can reach over -90kPa in short time, perfect drying performance through sterilization.

Device / Programs:
- 8 preset cycles
- Cycle time: 45-60 min, according to different loadings
- Pressure display: Analogue pressure gauge for chamber on right side
- Temperature display: Digital Temperature Display on the front panel (LCD screen)
- Built-in steam generator: Double Instant steam generator
- Integrated programmable PLC control system with 3.2 inch LCD screen display and capacitive induction buttons enables intuitive operation. It shows the pages which are: main menu, library cycles, cycle parameters, process control, display of temperature, pressure, time, running process, error and alarm information, various of messages (working status, temperature, pressure, vacuum, etc.)

Installation
- Designed Pressure: -0.1~ 0.3 MPa
- Vacuum low limit: -0.09 MPa
- Vacuum pulses counts: 0~99 items
- Designed Temperature: 144�° C
- Working Temperature range: 105-138�° C
- Power Supply: control Power: AC 220V �± 10% single phase 50/60 Hz
- Input power: 2.6kVA (24L) or 6.8kVA (45L) or 7.4kVA (60L)
- Water pure supply, inner circulation, with open type water tank with removable cover makes it easy to be cleaned


Data Saving:
- Sterilization cycle data (batch number date/time, temperature/pressure progress and sterilization phase) can be printed using an integrated micro printer (optional) via RS232 serial port
- Data can also be stored via U disk (optional), stores up to 10 000 sterilization cycles
- WI-FI module allows real time transmission of cycle data and cycle progress information to a PAD for online monitoring (documented data both graphically and numerically and can be used for control of autoclaves)

The Donkey. The product is very durable and repeat sales are mainly on the consumable burning gel (usually alsohol based gel). Functionality is complemented by economic benefits from very low usage of burning gel. You can buy our gel (DVDW GEL) or you can use your own.

10 Kg (600mm (l) x 600 mm (h) x 250 mm (w).

Gas cooker 5 burner with oven & grill with turn split , timer, oven light , oven thermostat spark ignition , wire shelf dish warmer different models

Container capacity 126
Gross weight: 70 kgs
Packing in carton box

Three Phase Induction Motors
Totaly enclosed
Alu. Housing up to 5.5 H.P
Cast Iron from 7.5 to 25 H.P
Speed 1000 , 1500 , 3000 r.p.m

Wooden case

Dimensions 60 x 90 cm.
Enameled - Stainless Steel.
Stainless working table.
5 top Gas burner.
Genius oven (capacity 115 liter).
Spark Ignition.
Oven Thermostat.
Turnspit.
Timer.
Wire Shelf & deep pan.
Dish Warmer.


We load 126 Applince in 40' HC

Dimensions 60 x 55 cm.
Enameled - Stainless Steel.
Stainless working table.
4 top Gas burner.
Genius oven (capacity 49 liter).
Spark Ignition.
Oven Thermostat.
Turnspit.
Timer.
Wire Shelf & deep pan.
Dish Warmer.



We load 162 Apliance in 40'HC