Polyurethane Windshield Adhesive is a component, moisture curing polyurethane based adhesive for direct glazing in Automotive Glass Replacement.
One component formulation
Good non-sag properties
Short cut-off string
Cold application
Fast curing â?? Rapid strength development
High mechanical performance
High Modulus
High initial bond strength
Can be overpainted
Akfix G400 is a two component marble and natural stone adhesive based on polyester resin.
Resistant to UV
Resistant to alkalis and diluted acid solutions
Temperature resistance of cured adhesive is between -10 C and +100 C
Bonded surfaces are ready to be used after 2 hours
No color change, cracking or shrinkage during hardening period
An adhesive set which consists of high viscosity cyanoacrylate adhesive and activator.
High bonding strength.
Suitable for use on vertical surfaces as it will not drip or slump.
It is particularly suited to bonding difficult substrates which have a porous or uneven nature since it increases bonding strength by preventing the adhesive to be absorbed by the surface.
One-component, fast curing liquid polyurethane adhesive. It possesses high water resistance and bonding strength.
Fast curing.
Low press time.
Transparent.
Extremely high bond strength on numerous substrates.
Conforms to D4 according to DIN EN 204.
Easy to use.
Very good resistance to chemicals.
Excellent resistance to moisture and weather conditions.
Nonshrinking.
Low odour.
Useable in slightly wet substrates.
Super glue is a single-component cyanoacrylate monomer in the liquid state, capable of extremely rapid polymerization between adherent surfaces, result-ing in extremely strong and structural bonds at room temperature.
This instant adhesive will, with only normal surface preparation, bond all materi-als commonly used in the engineering industry, except polyethylene. Polypropylene, teflon, and very porous surfaces, which require special treatment.
Super glue is a single-component cyanoacrylate monomer in the liquid state, capable of extremely rapid polymerization between adherent surfaces, result-ing in extremely strong and structural bonds at room temperature.
This instant adhesive will, with only normal surface preparation, bond all materials commonly used in the engineering industry, except polyethylene. Polypropylene, teflon, and very porous surfaces, which require special treatment.
To open tube:
1. Unscrew entire nozzle & cap unit.
2. Reverse cap and place pointed end on top of tube. Point tube away from face, Press to puncture. Do not squeeze tube while puncturing. After puncture is made, replace nozzle & cap.
3. Unscrew outer cap only and apply sparingly. Clean tip after each use.
Application:
Be sure both surfaces are clean and dry. Apply with extreme care. Never spread with fingers. Apply one drop for each 3 cm area. Apply to only one of the surface, Quickly place two surfaces together with slight finger pressure.
Bond is completed in seconds, or depending on material in about one minute, leave for 24 hours for strongest bond.
Clean away all excess adhesive from container with ties-sue paper. Keep out of reach of children, in cool dry place.
Warning: Keep out of reach of children:
Adhesive will stick to skin very quickly, when using, be sure it dose not come into contact with fingers, do not try to pull it off. Soak fingers in warm water and work off Nail polish remover may also be used. If adhesive get in eye, wash eye with quantities of plain water, do not try to remove by rubbing or applying solvents, in case of pain or discomfort, consult a doctor.
Bond for home uses:
For mending dishes and household articles, tables, chairs, bureaus and other articles of furniture, fishing tackle and other sports equipment, or for use on metal, leather or paper.
Supplier: Polyurethane pu foams, sealants mastics
waterproofing membranes, industrial adhesives, glues, technical aerosols
anaerobics
polyurea systems
rigid polyurethane pu spray foam
systems
surface preparation and repair systems
epoxy primers and floorings
