pump impellers are interchangeable with AH/HH/LM pump impellers, The Impeller is one of the most important parts for slurry pump. Centrifugal slurry pumps need impeller to produce the centrifugal force which transfer the . The centrifugal force is produced by the impeller which rotates to a certain speed, As main rotating component which normally has vanes to impart the centrifugal force to the liquid, Usually, slurry pump impellers have a plain or a Francis type vane.
11 inch Impeller 19121-70-30 is used for 6x5x11 Mission Magnum Centrifugal Sand Pumps.
provides 19121-xx-30 impellers for Mission Magnum centrifugal pump 6x5x14:
19121-70-30 Impeller 6 x 5 11 inch
19121-80-30 Impeller 6 x 5 12 inch
19121-90-30 Impeller 6 x 5 13 inch
19121-A0-30 Impeller 6 x 5 14 inch
Fully open impeller, best design for the chemical process industries services. Ideally suited for corrosives and abrasives, handles solids and stringy fibers with ease. Allows for simple restoration of clearances when wear takes place. Back pump-out vanes reduce pressure on the shaft seal, reduce axial thrust on the bearings.
Part size cast into the impeller. This makes part identification easier.
Impeller gasket in included with impeller
All impellers are dynamically balanced
Offered Hard iron and other materials upon request
Supplier From
Busan,
South Korea (Republic Of Korea)
Supplier: Pump pv22, used korean hyundai & kia engine with gearbox, organic fertilizer, used volvo and scania engine with gearbox, arnold palmer golf shoes
19206-XX-30 Impeller for Mission Magnum 4x3x13 Centrifugal Pumps.
Fully open impeller, best design for the chemical process industries services. Ideally suited for corrosives and abrasives, handles solids and stringy fibers with ease. Allows for simple restoration of clearances when wear takes place. Back pump-out vanes reduce pressure on the shaft seal, reduce axial thrust on the bearings.
Part size cast into the impeller. This makes part identification easier.
Impeller gasket in included with impeller
All impellers are dynamically balanced
Offered Hard iron and other materials upon request
All impellers are investment casted or resin-casted with pickling (acid washing) as our power-end parts, which are also available in cast steel in favor of ductile. All other sizes are resin-casted with pickling (acid washing) to ensure smooth surface finish. To ensure quality, we meticulously check threaded holes by fitting their bolts to ensure the threads are clean and clear. All casings are of course pressure tested and all impellers and dynamic balanced. Each casing is properly pressure tested prior to shipping.
Impellers - wide variety of metallurgic and elastomeric options (metal and elastomer interchangeable) pump out vanes on rear and front (on closed impellers) reduce recirculation within pump, and aid in preventing seal contamination optional castings of straight or semi-Francis vanes (from 3 to 8 vanes on certain sizes) offer wider hydraulic options in single sizes.
Liners - wide variety of metallic and elastomeric options (metal and elastomer liners are interchangeable) to select from in order to provide the longest wear life possible.
Bearing assembly - Cartridge-style bearing housing allows for removal from pump and assembly in controlled environment, Oversized shaft diameters and reduced overhang in the wet-end contribute to long life and reliability in the field.
Seal arrangements - Expeller (Centrifugal Seal): no external sealing water required where applicable. Stuffing Box: flushed gland sealing with braided packing and a lantern ring. Mechanical Seals: advanced sealing technique without sealing leakage.
