Welded on metal bellow
Max. capacities 5 kg...2 t
Load cells and mounting aids
entirely made from stainless
material
Complies with OIML R60
regulations up to 6000 d
Six-wire circuit
Optimized for parallel connection
with corner-preadjustment
Meets today EMC/ESD
requirements according to
EN 45501
Explosion proof version acc. to
ATEX 95 optional
Get the motion status( including linear acceleration, high/low frequency, etc.) through Measuring the acceleration, can be applied in different media(ultra-temperature, low temperature, intense radiation environment etc.)
Weight:0.8-110g
Measuring Range:500-10000g
Temperature:-200 to 649ºC
(Hz) Frequency Response: 1-10000
(Pc/g)Senbility:0.75-200
Vibration transducer works based on the piezo effect of the piezoelectric materials. Current product can stand 482°C, used on aircraft engine health analysis system.
Meanwhile, our products are widely used in different industries.
1. Piezoelectric Vibration Sensor
Operating Temperature: -200ºC~649ºC
Measuring Range:500g
Frequency Response:10Hz~2500Hz
2.Application:
1) Aircraft, Engine and other industries facility
2) Aircraft engine health analysis system
3) Vibration Monitoring(such as gas turbine and auxiliary power system,etc.)
4) Vibration Tester: Manually vibration monitoring instrument
RIT001 has a high gain and measurement accuracy in the full bandwidth range, due to the application of the
multi-point zero-flux technology system and high-frequency ripple sensing channel on top of currently existing
DC sensor technology.
Primary Nominal Current: DC0.01,
Overload Capacity: 200% for 1 minute,
Power Supply: DC14.2V to 15.8V,
Output Voltage: ±1V,
Accuracy: 1%,
Linearity: 0.2%,
Zero Offset Voltage: ±10mV,
Dynamic Response Time: 2ms,
Frequency bandwidth(-3dB): up to 100KHz,
Insulation Voltage (Between primary and secondary): 5KV,
Operation Temperature Range: -40 ~ 85.
Nominal Current(RMS):25/50/75/100A
Vout@Ipn:+_25/50V
Measuring Range:0~+_150A
Supply Voltage DC:+-12-15V
Accurancy@Ipn,+25degree Celsius:less than +_0.5%
Mounting(mm):7.0*12.7
 * Closed- loop                                        * Supply voltage: DC +-12~15V
 * Capable measurement of currents: DC, AC,pulse with galvanic isolation between primary circuit and secondary circuit.
BMS300 fluxgate transducer is made of an excitation magnetic ring and a control circuit. Under normal
conditions, the control circuit generates a fixed excitation current frequency to alternately place the magnetic
core at the maximum saturation point. When the measured current flows, the primary current is measured by
detecting the symmetry of the saturation point.
The BMS series is suitable for battery monitoring systems that require high accuracy and low offset.
It can realize the isolation measurement between the primary current (high voltage) and the secondary
current (12V system).
