Rotor types Y-shaped (120 angle)
Height x Width x Depth/Passage Width (mm) 2208 1510 1330/650
Case brushed stainless steel
The Raptor Y Max full-height turnstile solves the problem of restricting access for facilities with high perimeter security requirements. The Y-shaped modification leaves more room for passage, making it faster and more comfortable for the user, while maintaining absolute reliability of protection against unauthorized access, thanks to the locking system with smart-rotor position control function. The new mechanism was developed taking into account the high requirements for operational characteristics, including climatic conditions and reliability, therefore not requiring frequent maintenance, which gives the option to use the turnstile in places where it is difficult to set-up a permanent guard post. Raptor Y Max can be integrated with most access control systems available on the market, which means you can use it as part of an existing access control system, or choose the option that best suits your needs.
7 Pipe Valves Suppliers
Short on time? Let Pipe Valves sellers contact you.
Products are to cut INOX, metal pipes, stones, carbon and alloy steel, nonferrous alloys, railways, rounds, framing, stones and etc. Cutting-off wheels are an effective tool for processing mineral and synthetic materials. Abrasive wheels can be used for all types of grinding, excessing metal elimination, weld joint and burr grinding.
LLC â??TVC â??UKRABRAZIVâ?? is certified and meets the requirements of ISO 9001:2009. Our products are manufactured in compliance with EN 12413, EN 13743 and DSTU GOST 21963:2003.
We produce high performance abrasive cutting-off and grinding wheels based on fiberglass impregnated with phenol-formaldehyde resin of various diameter (from 115 to 400mm) and thickness (from 0.8 to 10 mm) which provide maximum quality of performed work, cutting of different materials with precise sawing. Our cutting, grinding wheels and flap discs are characterized by long-term service, high cutting value and G-ratio, high efficiency and safety securing.
LFG-50 & PT-14 Сable tracing and fault location set, can be used for locating as well as tracing underground metal communications, such as any cables with metal cores as well as metal pipes. In addition, it provides operator with a quick detection of short circuits on cables as well as with an identification of a cable in a bunch.
LFG-50 is a 50 W low frequency generator with ability to inject a signal of three frequencies via direct connection to an object or via internal transmission loop antenna, which is built-in a cover lid. Basic frequencies are 491; 982 and 8440 Hz. There are options of using a single-frequency or multi-frequency signals at the output.
The power of the low frequency generator LFG-50 output signal can be adjusted up to 50 W with 2.5 W steps. This signal can be transmitted constantly or broken into separate blocks of 50 % duty cycle with 1 s repetition rate.
Portable and lightweight
Moistureproof and dustproof case
Advanced LiFePO4 internal battery with fast charging option
High-contrast graphic OLED display
Multifrequency operation
Operating frequencies can be changed upon request
Internal transmission loop antenna
Automatic load impedance matching
Ability to work with energized 0.4kV cables (inductive connection)
Overload protection
Сable locator PT-14 designed for fast and accurate searching for power cables and other communications, identification of coating defects and the depth, followed by mapping.
