Mask-N95, Standard : EN149:2001 + A1:2009
Product origin : Turkey
Don't get confused, definetely better than Chinese products and safe. Inspections to our factory or short term contracts to close countries possible.
Monthly maximum capacity: 600.000 N95 masks.
Our products are produced in 3 layers and our production line is made in environments containing 100% hygiene. There is a special layer between the outer and inner protective layer for filtering purposes. Our products are produced in European norms and the production standards are fully tested and presented to our customers.
The S9 self-priming respirator is a reusable face mask designed to KN95 standards. This means that it will block > 95% of all particulate matter in the air larger than 2 �¼m in size. The mask employs inexpensive replaceable filters.
Breathe comfortably with full protection
Minimize cross contamination with plastic shield
Fits snugly on the face with silicone construction
Effective filter with four (4) layers
One time fit (No need to continually adjust for comfort)
Environmentally friendly because it is reusable
Personalize individual masks by attaching identification to it directly
Nasal High Flow Therapy for Spontaneously Breathing Adult Patients in Hospital and Long-Term Care Facilities
Respiratory support delivered through a soft nasal cannula interface
Wide flow range from 10-60 L/min* in 0.5 L/min steps to permit flow rate to be tailored to the specific needs of the patient
Ability to supplement oxygen with 0-60 L/min flow and up to 100% FiO2 from wall supply, oxygen cylinder, or concentrator
Integrated flow driver provides flow without the need for wall air supply
Warmed humidification of respiratory gas all the way to the patientâ??s nose to enhance therapy comfort and aid in mucous clearance1,2
Condensate-free delivery of a consistent, high-velocity flow during inspiration and exhalation
Auto-identification of type of nasal cannula and breathing circuit to improve and simplify workflow through automated configuration
Bacterial/viral filter between device and patient, rather than between device and room air, to reduce risk of cross-contamination
The tissue adhesive Histoacryl consists of monomeric n-butyl-2-cyanoacrylate, which polymerises quickly in connection with tissue fluid. Histoacryl is available in two colours: translucent, special for facial application, and blue, which enables an easy control over the quantity applied in different indications approved
The mobile blood donation tool is manufactured as a cabin with a volume expanding 1 meter to the right and left. Cab expansion is hydraulically controlled.
- The cabinet is insulated against heat, water and dust. The cabin walls, the base of the cab and the cabin doors are made of glass-reinforced polyester material (FRP) that does not advance flame and extinguishes itself. The panels are filled with 4 cm thickness and 32 density density foam material. Panel walls are produced with wet technology. The walls are mono-block. Walls and frame are supported by box profiles.
- Cab floor covering is made of 18 mm polywood material. It is covered with 2 mm epoxy or PVC floor covering to provide water and dust insulation.
- There are entrance and exit doors equipped with handrails in front and behind the cabin. In the design, the emergency exit scenario is taken into account and all doors must be locked from both inside and outside. The gas piston system is added so that all doors can be self-closing.
3514 Medical Healthcare Suppliers
Short on time? Let Medical Healthcare sellers contact you.
