Mjrs-2 Electrical Roll Stand

Characteristics:
1) The structure is symmetrical, can load two rolls raw paper at the same time, can change the paper roll without stop the machine. The tighten, loosen, up and down, move for center, left and right moving all use electrical control.
2) Effective working width: 1800mm.
3) Max. raw paper diameter: 1400mm
4) Min. raw paper size: 400mm 900mm
5) Max. load of single arm: 1500kg.
6) Each roll sand has two paper roll sending rails, two paper roll up dolly. Rail is made from the welding of the 12# channel steel and direction-leading pole. The dolly is made from 12# channel steel, the length of the rail is 4500mm.
7) Use disk model brake, have handle and electrical models. (can choose.)
8) The clip head is cast-iron finial model or automatic double expanded model. (can choose.)
9) Electrical elements are centralized controlled, this highly improves the production efficiency.

Technological parameters:
1. Paper roll frame working model: Mechanical electrical operation.
2. Paper roll length scope: Max.: 1800mm Min.:900mm
3. Paper roll diameter scope: Max.: 1400mm Min.:400mm
4. Single side max. load: 1500kg.
5. Motor power: (all are planet cycloid motor)
  Clip motor: 0.75KW 4units 380V 50HZ
Up and down motor: 2.2KW 1unit 380V 50HZ

Paper roll up-dolly and rail:
1) On the dolly have direction-leading wheel, can send the paper roll stably.
2) Rails are installed inside of the floor, main body is made from 12# channel board and 12 cold drawl steel, the length of the rail is 4500mm.
3) Each roll stand has two paper roll sending rails, two paper roll up dolly, it can load the paper roll in two sides at the same time.