HS Code : 3902900020
25kg/drum, 180kg/drum
As per Customer Requirements or Standard Export Loading
HTPB has good diaphaneity,low viscosity, ageing resistance, low temperature performance and processing performance is good. HTPBcan be used in : - Adhesive - Coating - Rubber products - Sports runway - Propellant - Planes tires of structural materials, etc.
HTPB has good diaphaneity,low viscosity, ageing resistance, low temperature performance, Hydrolysis resistance, acid and alkali resistance, wear resistance and excellent electrical insulation properties
and processing performance is good. HTPB can be used in :
Supplier: 1 lv and mv power cables , telecommunication cables , lsfh , solar ,instrument and special cables.
2 copper rod 8 mm and copper wire from 1.60 to 3
3 pvc compounds
PE coil pipes and tubes for water and wire cable conduit PL231
The PE coil pipes and tubes can be used:
water pipe 4 â?? 6 â?? 1-inch black coil with pressure 1.6mpa, OD 20-75mm, WT 2.3-6.8mm
pe conduit cable embedded wire cable and optical cable, OD 20-200mm, WT 1.8-3.5mm
weak current protection tube and communication tube, OD 20-200mm, WT 1.8-3.5mm
We use new 100% pure raw PE material
WHY NEW MATERIAL HDPE PIPES?
1. Health performance
PE pipe processing without adding heavy metal salt stabilizer, no scaling layer, and no bacteria.
2. Corrosion resistance
It can resist various chemical media erosion, with no electrochemical corrosion.
3. Service life
Under rated temperature and pressure conditions, PE pipes can be used for more than 50 years.
4. Impact resistance
PE pipe toughness, high impact strength, heavy objects directly pressed through the pipeline will not break.
5. Connection performance
The strength of the hot melt or electric melt interface of the polyethylene HDPE pipe is higher than that of the pipe body, and the joint will not be broken due to soil movement or live load.
6. Construction performance
It has a lightweight pipe weight, a simple welding process, convenient construction, and a low overall project cost.
System voltage 415 V +/- 10%, 3 Phase, 4 wire AC
2. Frequency 50 Hz +/- 3%
3. Fault level Shall be designed for fault level of 50 KA for 1 sec
4. Grounding Solidly grounded neutral system
5.
Insulation level
a) Power circuit
b) Control circuit
2.5 KV / 1 minute
1.5 KV / 1 minute
6. Main bus bars
Shall be designed to carry continuous current rating of 1.2
times of incomer ACB unitâ??s continuous current rating and
STC of 50 kA for 1 sec. Temperature rise, short circuit
design shall be as per IS 8623.
Max. Current density for the material of bus bar shall be as
follows:
Copper: 1.6 Amp/Sq.mm
Aluminum: 0.8 Amp/Sq.mm (For Sl. No. 12 PCC)
