Fire Alarm And Fire Fighting Gas Extinguisher

Fire alarm and fire automatic fighting system should be installed in library, electronic communication rooms, computer rooms where water extinguishing is not allowed.
CM1004 is 4 zones conventional fire alarm and fire extinguishing control panel. It can equip smoke detectors, heat detectors, gas sensor, manual call points, sound light siren strobe alarm warning device.

L the controller has one 24VDC/1A POWER output (power-24 v,0V) to supply POWER to external devices.
L Controller has 1 way fault, 1 way fire alarm relay output.
L The controller has remote mute, remote alarm test, remote fault test and remote reset functions.
L The controller has remote emergency start, remote emergency stop and remote hand/automatic mode switching functions.
L The controller has cylinder pressure undervoltage signal receiving function and gas release feedback signal receiving function.
L The controller has valve function.
L The controller can set 0-75s delay valve function.
L The controller has the function of manually opening and closing the exhaust fan.
L The controller has RS485 interface, which can transmit alarm information with the upper computer or the floor repeat display.
Zone1-zone4: input alarm equipment for multi-wire smoke sensing, temperature sensing, manual alarm button, etc. ZONE1 and ZONE2 participate
Linkage "and" control output, ZONE3 and ZONE4 only alarm function, do not participate in linkage control output. It is recommended that ZONE1 be connected to multiple cables
- type smoke detector, ZONE2 connected with multi - line temperature detector. When both ZONE1 and ZONE2 alarm, the controller will enter the linkage loss
Out (The controller is in automatic state) state
Fire alarm and automatic fire control must be installed in communication room, warehouse, factory.