Cc-600Sp Epoxy Primer

Epoxy Red Oxide Primer

Epoxy Zinc Chromate Primer

Epoxy Zinc Rich Primer

Epoxy Primer Solvent Base

Epoxy Solvent Free Primer

Epoxy Zinc Phosphate Primer White (A+B)

Description
1. Tough film and good adhesion on the concrete, able to penetrate into concrete.
2. Good resistance to water , brine and chemicals. Excellent mechanical strength and physical properties.
3. Good resistance to impact and abrasion.
4. Easy application , drying fast.

Prepare to use
1. Mix base and hardener by the mixing ratio and Stir thoroughly, then setting at least 15 minutes. Thinner may be used to reduce viscosity.
2. Remove all foreign particles, oils, grease , rust and moistures from the surface before application.
3. Two packs product, must be used completely during the duration of its pot life.
4. Donâ??t apply when the temperature is < 10â??,>40â??, relative humidity is >90â?? or the surface temperature of substrate is not higher than the dew point for at least 3â??.
5. If the coating interval is exceeded , the surface of base coat must be roughened to insure adhesion.
6. Keep away from heat, sparks and flame.
7. Stored with good ventilation.
8. Keep adequate ventilation during application.
9. The actual coverage may vary, depending on application technique, job conditions and type of surface. Under brushing & rolling application the actual coverage is estimated at 70% of the Theoretical coverage and 60% for spraying.
**The parts of data base above could be affect by application condition at job site, please reference guide specification or contact with relative technical personnel.

Color : Clear
Drying time :
Tack-free : 2 hours
Hardness : 8 hours
Full cure : 7 days (grease)

Super Heat Duty and High Alumina Fire Bricks arethe products made fromdifferent fractions of refractory grog, fire clays and calcinedbauxiteof high purity.Thedifferent fractionsof theserawmaterials aremixedin counter current mixers and plugged for obtaining homogeneous mixture. The mixtureobtained hence,is then pressed in high capacity presses to give the desired shape and size.These pressed shapes are fired in high temperature tunnel kiln at

1300 C and above. These bricks are manufactured as per IS: 6 and IS: 8