Measuring Tools And Instruments

# Callipers Measuring range of 0-1000 mm;
# With and without fine tunning;
# Material – constructional or stainless steel;
# Mat chromed scale;
# Reading – 0.1 and 0.05 mm.

# Special callipers 3-point vernier calliper;
# 5-point vernier calliper;
# Marking-off vernier calliper;
# Weld seam gauge;
# Other types.

# Vernier depth gauges Measuring range of 0-500 mm;
# Reading 0.1 and 0.05 mm;
# Material – constructional or stainless steel;
# Mat chromed scale.

# Micrometers Measuring range of 0-25; 25-50; 50-75; 75-100 mm;
# Reading – 0.01 mm;
# Measurement reading surface of hard alloys (carbide).
Range 0-25 mm.

# Coordinate small size tables One-coordinate;
# Two-coordinate;
# Three-coordinate;
# Stroke along the coordinate: 0-25 mm

# Measuring stands Type A2 – with magnetic switch at the base;
# Type A4 – with cast-iron base and T-shaped groove;
# Type B3 – with square-riffled table;
# Micrometer holder.

# Smooth gauges Plug gauges – one sided;
# Plug gauges – two sided;
# Snap gauges.

# Thread gauges Thread plug calipers – one sides;
# Thread plug calipers – two sides;
# Thread ring gauges.

# Smooth rings Reference rings;
# Setting rings
Range: 6-150 mm.

# Squares and rulers Flat squares;
# Squares with base;
# Checking rulers;
# Templates.

# Angle gauges Protractor with lock screw
Range 80x120 – 300x500 mm;
# Protractor with sliding rod
Range 120x240 – 300x500 mm Reading - 1°

# Marking-off tools (scribers) Straight scriber – one sided (with knurled handle);
# Bended tip scriber – two sided (with knurled handle);
# Trammel for tracing and marking with small base;
# Vernier caliper with two needles and fine adjustment;
# Height gauge with fine adjustment.