YED Leeward Marine Grade Resin Patch Set, used in the shipbuilding and maritime industry to stop leaks and repair pipelines. It is a high-strength epoxy system specifically designed for emergency repairs.

The technical specifications and areas of use of this set are as follows:

Product Details and Capacity
Contents: 810 g Resin + 140 g Hardener (Total 950 g)
Temperature Resistance: Withstands temperatures up to 180C (356F), making it suitable for hot water and steam lines.
Certification: Approved by Phoenix Register of Shipping (compliant with maritime standards).

Areas of Use

This set is commonly used for repairing the following systems on ships:
Hydraulic Pipes: Patching cracks and holes in high-pressure hydraulic circuits.
Fuel and Oil Lines: Rapid sealing of leaks.
Fresh and Seawater Pipes: Repairing perforations caused by corrosion.
Exhaust and Steam Lines: Can also be preferred for these systems due to its high temperature resistance.

Application Tips

To achieve maximum efficiency from such products, pay attention to the following steps:
Surface Preparation: Thoroughly clean the application area from oil, rust, and dirt. Sanding the surface increases the resinâ??s adhesion strength.
Mixing Ratio: Mix the 810 g resin and 140 g hardener thoroughly until a homogeneous mixture is obtained.
Curing Time: The curing time may vary depending on ambient temperature. Avoid applying high pressure to the pipe until full curing is achieved.
Reinforcement: For larger holes, applying the resin in layers together with fiberglass mats will increase the strength of the patch.
Caution: Since hydraulic systems operate under very high pressure, it is vital to re-commission the system in a controlled manner after the repair and carefully monitor for any leaks.