This buylead is archived. Your inquiry will be sent directly to the buyer's email inbox, and they may respond at their discretion. However, you will not receive their contact details.
Product Name: Polyethylene Pre-Stzretched PE Carrier Sheets
Specifications:
- The carrier sheet will be coated with a hotmelt adhesive in order to duce a corrosion prevention Heat Shrink Sleeve.
- Hotmelt adhesive is coming from a melter and is dropped at 120-180 degC (depending of adhesive compound mix) on the carrier sheet of 1 mm thickness.
- The final product is a sheet with two (2) layers.
- Layer one (1) = PE Carrier of 1 mm thickness.
- Layer two (2) = Adhesive of 1.5 mm thickness.
Please provide a quotation to the following requirement from importer -
Product Name: Low Density Polyethylene (LDPE)
Specifications :
DPE MP3425 Complies With The Requirements As Below Indicated When The Product Is Processed Using The Correct Practice And Testing Procedures
Properties
Unit
Test Method
Typical Value
Density ( Compound ) At 23ºc
G/cm3
ASTM D 792
0.934
Melt Flow rate 2,16 kg al 190ºC
g/10min
ASTM D 1238
0.25
Melt Flow rate 5kg at 190ºC
g/10min
ASTM D 1238
1.0
Carbon Black Content
%
ASTM D 1603
Greater Than 2
Vicat Softening Point
ºC
ASTM D 1525
98
Melting point
ºC
ASTM D 2117
124
Brittleness Temperature
ºC
ASTM D 746
Less Than -70
Tensile strain at break
%
ASTM D 638
22
Tensile elongation
%
ASTM D 638
Greater Than 600
Hardness
Shore D
ASTM D 2240
50
E.S.C.R. 10% igepal F50
Hr
ASTM D 1693-A
Greater Than 5000
Oxidation Induction Time 210 ºC
Min
ISO 11357
Greater Than 20
