This buylead is archived. Your inquiry will be sent directly to the buyer's email inbox, and they may respond at their discretion. However, you will not receive their contact details.
Product Name: Brushless Hub Electric Car Wheel Hub Motor
Specifications :
Power Efficiency QS Motor 8000W V2 273 BLDC brushless hub electric car wheel hub motor
Desired PCD would be 5x114,3 (for a Honda 8th gen Civic)
MOQ of 2 units
Product Name: Dynamic Wind Generator Like Large Axial Propeller
Specifications:
Product Name: Large Axial Propeller For Dynamic Wind Generator
Special Note: Share CO Form E Your Company Made You Can Delete Information About The Customer, CQ .. And Provide The Drawing/ Datasheet
Application: open-jet dynamic wind generator for facade/window/door testing.
Fan/propeller type: large axial-flow propeller/impeller.
Horizontal shaft installation.
Inlet: free/open air inlet.
Outlet: open discharge/free jet.
A safety protection mesh and water spray rack will be installed between the propeller and test specimen.
Required air velocity at the specified test plane: = 36 m/s.
Equivalent dynamic pressure at 36 m/s is approximately 794 Pa at ? = 1.225 kg/m³.
Static pressure
Propeller diameter range: 2,500–3,000 mm; supplier may recommend optimum diameter.
Variable-speed operation by VFD from low speed up to at least the 36 m/s test condition.
Continuous operation shall be possible at the 36 m/s design condition.
Proposed propeller diameter.
Hub diameter and hub-to-tip diameter ratio.
Number of blades.
Blade material and material grade.
Hub material.
Blade installation angle / pitch angle at design point.
State whether blade pitch is fixed or adjustable.
Dynamic balancing grade of propeller assembly.
Propeller assembly mass.
Rotational speed corresponding to 36 m/s at the test plane.
Maximum allowable rotational speed.
Shaft power at design point.
Recommended motor power.
Propeller/fan efficiency at design point and basis of determination.
Guaranteed vibration level.
Expected noise level and measurement condition.
Detailed drawing of the impeller.
Quantity Required : 1 Less than Container Load/LCL
