This oxygen and nitrogen generation system uses pressure swing adsorption principles at normal temperatures, along with clean, compressed air as the raw material, and a carbon molecular sieve as the adsorbent. Due to different adsorption of oxygen and nitrogen onto the carbon molecular sieve surface as well as different diffusion rates through the open or closed program control valve, separation of the two gasses is achieved, and nitrogen of required purity is produced.
Methanol is converted to co and h2 with the action of the catalyst; -co and h2o are converted to co2 and h2 with the action of the catalyst; -co2 and trace co are separated from the decomposed gases by psa technology, and high purity of h2 is generated.
The system vaporizes liquid ammonia, and heats it with a catalyst until decomposition occurs, creating a mixture of gas consisting of 75% hydrogen and 25% nitrogen. Based on the principle that the molecular sieve adsorbs ammonia and water at different temperatures, high purity gas is produced by heat regenerating through the mixture working at normal temperature.Hydrogen production 5-500nm3/h Impurity oxygen 2ppm Residual ammonia 3ppm Dew point -65°c Working pressure 0.05-0.2mpa
This separation process occurs in an adsorption tower and is advantageous in its low cost, low capacity, minimal maintenance requirements and user-friendly interface. The h2 purifying system removes oxygen from hydrogen via a catalyst to obtain high purity h2 after adsorption and drying through the dust filter. The system can remove oxygen down to levels of 1ppm. Through one step of purification, the purity of the hydrogen generated can reach between 99.999~99.9999% and the dew point can be lower than -70°c; through a second purification step, impurities can be , 0.8mpa H2 purity % >98-99.999% Dew point , -60°c Oxygen content , 1ppm
Solar panel photo volt product Wind mill & and dynamo Package weight: 8.000kg (17.64lb.) Package size: 65cm x 40cm x 32cm (25.59in x 15.75in x 12.60in)
Introduction: Hydrogen electrolyte and oxygen electrolyte circulate separately, hydrogen electrolyte pumps into hydrogen fuel cell directly and oxygen electrolyte pumps into oxygen cell directly, and therefore gets higher purity of hydrogen and oxygen gas. Specifications: O2 purity % >99.5 Power consumption (dc) < 4.5 kw.H/m3h2 Electrolyte 30% koh Work pressure 0.5-5.0mpa
Ntm engineering proposes designing gas turbine power plants of small, medium and large capacity. We carry our research, development and engineering projects under the terms of the order of the customer, provide the necessary technical documentation, offer new development, technologies, innovations in energy industry. Ntm engineering combines human talents and modern software technologies to create r&d projects quality and timely. Our high qualified specialists have a large experience in energy industry.
We would like to inform to you that we are planning to sale complete plant equipment and machinery of our 6mw 5°c 6 mw turbo-generator (triveni make f r -13) Power :6000 Year of manufacturing:2003 I / l steam pressure :65 kg/cm² I / l steam temperature :485°c Exhaust steam pressure :01 kg/cm²/ata Bleed steam pressure :3.5 kg/cm² Turbine speed :8280 rpm Out put speed :1500 rpm Trip speed range :9145 to 560 rpm 1st critical speed:3200 to 3600 rpm Oil :Servo prime-68 Triveni gear box Model no.:0560 Gear ratio :5.52 Rated input :8280 rpm Order no.:3730 No. Of teeth gr/pin :138 / 25 Oil :Iso vg-46 Bhel generator Frame :G651048 K.V.A:7500 Kw :6000 Rpm:1500 P.F :0.8 lag Stator volts :11000 Stator amps :394 Exct volts :122 Exct amps :387 Synchronous generation Connection :Star Inlet temperature :50 °c Ambient temperature :40 °c With regards Seshgirirau +91 9985252069
2. Circulating fluidized bed boiler is radically different from other boilers on the burning system. Its burning system consists of burning room, material destination and material returner. The high heat material enters the material returner together with the airflow, and the material collected will enter the material returner and then returns the burning room. This is called circulating burning which increase the burning efficiency greatly. 3. This boiler is with a wide range and high speed of load adjustment. 4. A clean and environmental burning technology is used in this boiler to improve the quality of air and environment. 5. It is easier to use the ash completely because of the low-heat burning and good burning condition of this boiler. 6. There is no immersed tube in the boiler, so it is easy to start or stop the equipment Upto 660mw
This is the conmibation of seawead extract, amino acid, humic acid along with other numbers of ingredents like fulvic acid , npk, micro nutrients Either in bulk or required packing from 100 ml to 5 ltr. With or without lable as per the requirement of the buyer
Nitro benzine base 20% and 50% for periodical spray for getting more flower, more yield and more profit Either in bulk or in required packing from 100 ml to 5 ltr. With or without lable as per requirement of buyer
An efficient sticker and breeder guarantees protection of spray solutions against rain , cloudy weather , dew drops and makes spread evenly. Either in bulk or required packing from 100 ml to 5 ltr. With or without lable as per requiremet of the buyer
We can be specially designed and manufactured by different output powers for hydro power stations according to different dam site conditions and environments.
Straight condensing turbine with gen. & boiler . 20 ton aprox.
Biomass gasifier and biomass gasification power plant we supply here is using 100% agricultural and forest waste as fuel. The biomass gasifier (reactor) can convert the above mentioned biomass fuel into syngas for thermal application and power generation. The company has developed and commercialized a wide range of biomass gasifier ranging from 50kw output to 1200kw output. The biomass gasifier and gasification system is applied to biomass power generation plant, biomass centralized gas supply for cooking and heating. The biomass gasifier and biomass gasification system can also be applied to replacing LNG and diesel oil for thermal application and baking & drying agricultural products. Our equipments have been serving in rice mill, timber mill, food industry (especially nuts), village, and Tobacco Company safely and reliably. Both downdraft fixed bed gasifier and fluidizedbed gasifier is available. If customers have special requirements, unique design, manufacture and delivery can be made on your demand. Applicable Fuel for biomass gasifier gasification system: Agricultural waste and residua, wood waste and residua, nut shell, other waste and residua. 1. Power Plant Scale: 200kw 2. Engine & Generator Type: gas engine and generator using 100% biomass gas as fuel 3. Rotary speed of engine: 1500Rpm 4. Gasifier Type: Fixed bed downdraft biomass gasifier 5. Gasifier Gas Output: 750Nm3/hr 6. Gasification Agent: Air 7. Gasifier Outlet Gas Temperature: 700-800 degree 8. Gas temperature after Cooling: Below 45 degree 9. Biomass Fuel Consumption: 400-440KG/Hr 10. Biomass gas heat value: Normally 3000-6000KJ/Nm3 11. Application: for power generation or for thermal application 12. Site area requirement: about 90 square meters. The whole gasification process is environment-friendly with low NOx in the engine exhaust and nearly no sulfur oxide emission (SOx). H2S is very less, which usually can be ignored.Welcome to contact with us for more information.
The biomass gasifier and biomass gasification power plant we supply here is using 100% agricultural and forest waste as fuel. The biomass gasifier (reactor) can convert the above mentioned biomass fuel into syngas for thermal application and power generation. The company has developed and commercialized a wide range of biomass gasifier ranging from 50kw output to 1200kw output. The biomass gasifier and gasification system is applied to biomass power generation plant, biomass centralized gas supply for cooking and heating. The biomass gasifier and biomass gasification system can also be applied to replacing LNG and diesel oil for thermal application and baking & drying agricultural products. Our equipments have been serving in rice mill, timber mill, food industry (especially nuts), village, and Tobacco Company safely and reliably. Both downdraft fixed bed gasifier and fluidizedbed gasifier is available. If customers have special requirements, unique design, manufacture and delivery can be made on your demand. Technical Parameter for 100kw downdraft biomass gasifier gasification power plant 1. Power Plant Scale: 100kw 2. Engine & Generator Type: gas engine and generator using 100% biomass gas as fuel 3. Rotary speed of engine: 1000Rpm 4. Gasifier Type: Fixed bed downdraft biomass gasifier 5. Gasifier Gas Output: 375Nm3/hr 6. Gasification Agent: Air 7. Gasifier Outlet Gas Temperature: 700-800 degree 8. Gas temperature after Cooling: Below 45 degree 9. Biomass Fuel Consumption: 200-220KG/Hr 10. Biomass gas heat value: Normally 3000-6000KJ/Nm3 11. Application: for power generation or for thermal application 12. Site area requirement: about 50 square meters. The whole gasification process is environment-friendly with low NOx in the engine exhaust and nearly no sulfur oxide emission (SOx). H2S is very less, which usually can be ignored.
The biomass gasifier and biomass gasification power plant we supply here is using 100% agricultural and forest waste as fuel. The biomass gasifier (reactor) can convert the above mentioned biomass fuel into syngas for thermal application and power generation. The company has developed and commercialized a wide range of biomass gasifier ranging from 50kw output to 1200kw output. The biomass gasifier and gasification system is applied to biomass power generation plant, biomass centralized gas supply for cooking and heating. The biomass gasifier and biomass gasification system can also be applied to replacing LNG and diesel oil for thermal application and baking & drying agricultural products. Our equipments have been serving in rice mill, timber mill, food industry (especially nuts), village, and Tobacco Company safely and reliably. Both downdraft fixed bed gasifier and fluidizedbed gasifier is available. If customers have special requirements, unique design, manufacture and delivery can be made on your demand. Applicable Fuel for biomass gasifier gasification system: Agricultural waste and residua,Wood waste and residua,Nut shel,Other waste and residua. The whole gasification process is environment-friendly with low NOx in the engine exhaust and nearly no sulfur oxide emission (SOx). H2S is very less, which usually can be ignored.Welcome to contact with us for more information. Technical Parameter for 400kw biomass gasifier - biomass gasification power plant 1. Gasifier Type: Fluidized bed biomass gasifier 2. Gasifier Gas Output: 1500Nm3/hr 3. Gasification Agent: Air 4. Biomass Fuel Consumption: 520-720KG/Hr 5. Biomass gas heat value: Normally 3000-6000KJ/Nm3 6. Application: for power generation or for thermal application.
The biomass gasifier and biomass gasification power plant we supply here is using 100% agricultural and forest waste as fuel. The biomass gasifier (reactor) can convert the above mentioned biomass fuel into syngas for thermal application and power generation. The company has developed and commercialized a wide range of biomass gasifier ranging from 50kw output to 1200kw output. The biomass gasifier and gasification system is applied to biomass power generation plant, biomass centralized gas supply for cooking and heating. The biomass gasifier and biomass gasification system can also be applied to replacing LNG and diesel oil for thermal application and baking & drying agricultural products. Our equipments have been serving in rice mill, timber mill, food industry (especially nuts), village, and Tobacco Company safely and reliably. Both downdraft fixed bed gasifier and fluidizedbed gasifier is available. If customers have special requirements, unique design, manufacture and delivery can be made on your demand. Applicable Fuel for biomass gasifier gasification system: Agricultural waste and residua,Wood waste and residua,Nut shel,Other waste and residua. The whole gasification process is environment-friendly with low NOx in the engine exhaust and nearly no sulfur oxide emission (SOx). H2S is very less, which usually can be ignored.Welcome to contact with us for more information. Technical Parameter for1200kw biomass gasifier - biomass gasification power plant 1. Gasifier Type: Fluidized bed biomass gasifier 2. Gasifier Gas Output: 4500Nm3/hr 3. Gasification Agent: Air 4. Biomass Fuel Consumption: 1.8-2.2Ton/Hr 5. Biomass gas heat value: Normally 3000-6000KJ/Nm3 6. Application: for power generation or for thermal application.
Manufacturer pompetravaini italy, made in year 2002. Vacuum pump is two staged rotating pump with externally located, grease lubricated bearings. Pump is liquid ring type designed for water sealed operation. The impeller and shaft are made of stainless steel (aisi 316), cast iron casing and manifold normal steel. The shaft is sealed with double mechanical seal. Pump is provided with connections for service water and draining. Pump includes also anticavitation valve. Pump is dismantled from its base frame but the delivery includes original electric motor eex classified abb hyr 200m lb 4 30 kw, 1476 rpm, year 1995. The equipment will be supplied loose - not as a skid. Technical data:trch 80 - 540/c2/ra Max suction pressure:25 mbar (till 300mbar) Max capacity:540 m3/h (min 400 m3/h) Flanges:80 mm Rotation speed:1500 rpm Power requirement:30 kw at 1500 rpm Year made:2002 Condition:fully operational
The recovery plant is specially designed to recover CO2 from fermentation processes at breweries. This complete CO2 plant was installed in 2001 and it has nominal CO2 removal capacity of 1000 kg/h. The plant has Siemens S 7 control system where operation is carried our via a large 12 " color screen panel with Windows CE operating system. This is a complete CO2 recovery plant and final delivery scope depends on buyers needs. The plant has been in operation only approx 5 years and is still installed and in very good condition. The carbon dioxide plants was designed by Danish Union Engineering (www.union.dk ) and the delivery includes following main components: - 1 Scrubber for gas flushing - 2 Foam catcher vessels - CO2 collection, inflammable - 2 Mehrer TZW 70 CO2 compressors - 2 Carbon filters - 2 Dehydrators - CO2 Liquefier - CO2 Storage Tank - 2 Cooling compressors GEA Grasso GD-3 for R717 - Air cooled condenser for NH2 compressors - Alarm center for CO2 and NH3 concentration - Station for 40 kg CO2 still tank filling - CO2 pumping station from a truck to the factory - CO2 purification tester - Steam heated evaporator for liquid CO2 Detailed technical information available for serious buyers
