With built in power supply to operate cathode ray tube, on voltmeter shows deflection voltage, C.R.T is mounted on teak wood stand with graph. Anothre wooden stand is provided to hold bar magnets and deflection magnetotomer.
To study frequency and waveshape generated by Colpitt Oscillator, instrument comprises of 12 V DC regulated power supply.
To study frequency and waveshape shift Oscillator instrument compreses of 12V DC regulated power supply, printed cicuit diagram & components mounted on fron panel.
Range 1 Hz to 100 Khz in five bands, Sine, Square nad Triangular wave with output voltage variable upto 20 volts peak to peak at
Wit built in stabilized power supply, workable on 230 Volts AC, thermister fitted with built in oven and thermometer is mounted on front panel, a heat control switc, on mili ammeter 10mA, on voltmeter 10V and separate terminal for thermister are provided.
Instrument comprises of DC regulatored power supply, printed circuit diagram and component mountedon the fron panel
Instrument comprises of two DC regulated power supplies of 0-5 Volts and ±15 volt on digital meter to measure input and output voltages, combination of reistances, capacitors mounting on fron panel
Consists of steel C.P. rod one meter long, two adjustable knife edges facing each other, two cast iron weights are provided to slide along the length of the bar and can be clamped in any position, two hard wood weights can be used to compensate iron weights. The apparatus is used to find acceleration due to gravity at a place.Iron / Brass CP Parts
Brass C.P. for experiments on rigidity. It consists of a hollow cylindrical brass tube open at both ends with a chuck carrying a mirror. The tube is graduated in mm on both sides, 2 hollow cylinders, all 10cm long, fitted in the bore of the tube, provided with wall clamp
To Find the modulus of rigidity & Young’s Modulus for a wire. The 30cm long wire under test is connected to two brass rods 30cm long. Complete with test wires with connecting screws
Consists of two cast iron feet, two supporting rods, one wheel with groove moving on ball bearings is provided with chuck to hold the test rod, aluminium scales with pointer are attached to specimen rod.Available with Half meter long rods and two scales & with one meter long rods and three scales.
It consists of a mild steel frame mounted on a heavy cast iron base fitted with levelling screws, three sliding circular scales graduated in degrees are provided which can be clamped at any position on one of the frame uprights, three pointers for clamping to the test rod are provided
To determine Young’s Modulus of a wire. It consists of two rectangular frames connected by a link. The frames are fitted with self cantering chucks, provided with a spirit level a speedometer, a cast iron ceiling attachment and weight.Available : Iron / Brass Frame
Comprising a metal bar one meter log resting on knife edges of two heavy table clamps, hanger with knife edge moves on metal bar, a spherometer fitted on cast iron stand with electric contacts is also provided
20cms in dia and 45mm wide, accurately balanced wheel is mounted on a horizontal shaft held in ball bearings. The wheel is marked and a pointers fixed to the bracket. The bracket has four holes and can be fixed tot the wall.Available : With / Without Counter Available : With / Without Counter
Vernier Callipers with Digital Read Product Description : Conversion button, on/off switch and zero setting switch. Metal knob for locking the device is provided at the top.
Micrometer with rachet stop, dull chromium plated brass body, accurately threaded M.S.. rod. Zero Correction screw is provided at one end of the body. Packed individually in beautiful printed duplex box. Pitch 1mm Avaialble : 10 / 15 / 20 / 25 mm
For taking direct readings. The micrometer is provided with mm/ inch conversion button, on/off switch and zero setting switch. Lever for locking the device is provided at upper part of the body. Battery compartment is at the back of the body.