Impeller

pump impellers are interchangeable with AH/HH/LM pump impellers, The Impeller is one of the most important parts for slurry pump. Centrifugal slurry pumps need impeller to produce the centrifugal force which transfer the . The centrifugal force is produced by the impeller which rotates to a certain speed, As main rotating component which normally has vanes to impart the centrifugal force to the liquid, Usually, slurry pump impellers have a plain or a Francis type vane.

V6 C.I. Diffuser & Nylon Impeller 50 Feet Submersible Pumpset

Impeller for 8AHF Pump

Description 11 inch Impeller 19121-70-30 is used for 6x5x11 Mission Magnum Centrifugal Sand Pumps. provides 19121-xx-30 impellers for Mission Magnum centrifugal pump 6x5x14: 19121-70-30 Impeller 6 x 5 11 inch 19121-80-30 Impeller 6 x 5 12 inch 19121-90-30 Impeller 6 x 5 13 inch 19121-A0-30 Impeller 6 x 5 14 inch Fully open impeller, best design for the chemical process industries services. Ideally suited for corrosives and abrasives, handles solids and stringy fibers with ease. Allows for simple restoration of clearances when wear takes place. Back pump-out vanes reduce pressure on the shaft seal, reduce axial thrust on the bearings. Part size cast into the impeller. This makes part identification easier. Impeller gasket in included with impeller All impellers are dynamically balanced Offered Hard iron and other materials upon request

OEM Andritz ACP series pump spares Impeller ACP 150-400.5 semi-open type in a highly wear-resistant design.

Impeller Material: 45# Weight:0.623kg Process:Investment casting Description: An impeller is a rotor used to increase (or decrease in case of turbines) the pressure and flow of a fluid.

Medium: flue gas with sintering dust Dust content: 100mg/Nm3 Flow rate: 550000m3/h Full pressure: 150mmH2O Speed: 580 rpm Working temperature: 280 degrees Maximum temperature: 350 degrees

Interchangeable Pump Parts Impeller ACP 80-250 3+3 SO of EN.1.4474 are widely used for highest efficiencies in various industrial applications.

Description 19206-XX-30 Impeller for Mission Magnum 4x3x13 Centrifugal Pumps. Fully open impeller, best design for the chemical process industries services. Ideally suited for corrosives and abrasives, handles solids and stringy fibers with ease. Allows for simple restoration of clearances when wear takes place. Back pump-out vanes reduce pressure on the shaft seal, reduce axial thrust on the bearings. Part size cast into the impeller. This makes part identification easier. Impeller gasket in included with impeller All impellers are dynamically balanced Offered Hard iron and other materials upon request All impellers are investment casted or resin-casted with pickling (acid washing) as our power-end parts, which are also available in cast steel in favor of ductile. All other sizes are resin-casted with pickling (acid washing) to ensure smooth surface finish. To ensure quality, we meticulously check threaded holes by fitting their bolts to ensure the threads are clean and clear. All casings are of course pressure tested and all impellers and dynamic balanced. Each casing is properly pressure tested prior to shipping. Our impellers are comparable to famous pump