NiZn Ferrite powder
Saturation Magnetic Flux Density:3000gauss;
Relative Temperature Coefficient:30-150
Electrical Resistivity:10 7Î©.m
Working Frequency:0.1-2.0MHz Sintering temperature:1080â??
Supplier: Barium ferrite powder, rubber magnetic strip, rubber magnet, ferrite sintered magnet, hard ferrite magnet, custom ferrite magnets, ferrite core, ferrite rods, ferrite strips, ferrite pins
We, nanjing herui international co., ltd., is trading company of herui group, which are mainly exporting magnetic materials produced by our plant located in nanjing , china. Our magnetic materials including magnetic powder, ferrite magnet(hard and soft), magnet strip. Such as : segment, ring and cylindric magnet , Square and bar magnet , square magnet with hole , Based on y30h-1, y30h-2, y33, y35 Segment magnet Wet press segment magnet is our main product with 3000 tons capacity. The magnets are mostly used in automotive(such as wiper, window lift, blower, abs, seat and fuel pump motors), motorcycle, electric-tool, fitness equipment and home appliance etc.Produce by powder metallurgical method , chemical composition of sro6fe2o3 , relatively brittle & hard , good resistance to demagnetization , excellent corrosion resistance , good temperature stability , raw material is readily available & low in cost. Pigment: Our company also able to export pigment from china for paiting and coating. Which used in wall&road painting , ground tile, etc We can provide you iron oxide red, iron oxide yellow, iron oxide green, iron oxide black. The most important is we can produce any kind of color and grade as per your instruction. We can produce purely same products as per your counter sample and stardard. - Wooden carton
Supplier: Permanent magnets: ndfeb, ferrite, alnico, smco, flexible magnet, magnetic powder and magnetic assemblies.
Services: Manufacture products according to customer's design, drawing and requirement.
Description : Plastic-bonded magnets are particle composites with permanent-magnet powder embedded in a plastic binder. Hard ferrite (HF), various SmCo and NdFeB powders and, to a very little extent, AINiCo alloys are used as magnetic powder. For embedding the magnetic particles, thermoplastic binders as, for instance, polyamide (PA) or polyphenyl sulfide (PPS) and duroplasts like epoxy resins are used. Depending on the material composition and production process, isotropic and anisotropic magnets with differing magnetic and mechanical specifications are available. Since not only the type of magnet or plastic material, but the filling and alignment degree, too, determine the composite`s properties, the outcome is widely varying magnetic parameters and an outstanding variety in types and shapes.