We have stocks 56000 pieces of : Inductor RF Chip Shielded Wirewound 10uH 20% 10MHz Ferrite 0.12A 5.405Ohm DCR 0402 T/R Reference name: LQW15DN100M00D Inductor Surface Mount ( from Murata Manufacturing). We propose to sell it.(+ shipping from Hong Kong.) Price to be discussed FOB.
1.Features: Good constant inductors properties and anti-dc bias capability. With low-loss 2.Applications: . Output filter inductors, smoothing inductors, energy storage inductors . Energy-saving lamp electronic ballasts, and the differential-mode inductance in the EMC filter
Ratio 1000: 1 , 2000:1, 1000:5 (customized) Accuracy class 0.1%, 0.2%, 0.5% Primary current 0 - 500A AC and 0-1000A AC Signal output 1mV/A, 1mA/A Secondary voltage 0 - 0.5V AC and 0 - 1V AC; Secondary current 0-1A or 0-5A AC Max. Cont. Input current 1200A Load capacity 4 Over voltage category CAT III 600V Frequency range 10Hz-10MHz Dielectric strength 3KV 50Hz/60Hz at 1minute Temperature range -40C to +55C Output 2.5 meter cable with D01 or BNC connector Max. voltage not insulated conductors 600 V Standard EN 61010-1, EN 61010-2-032, IEC60044-1 Installation clamp type Output mode lead output(2.5m) Accuracy (1000A Range) 0-10A 0.5% 10-100 0.2% 10-1200A 0.1% Phase Shift(1000A Range) 0-10A 0.5 10-100 0.2 100-1200A 0.1 Mechanical parameters Dimensions (L x W x H) (mm) 105 x 218 x 30 Weight (g) 650 Holding wire diameter (mm) 52 Max. jaw opening (mm) 52 Jaw color Red & Grey Material PC+ABS, UL94 V0
FEATURES Suitable for 5A, 10A cable online measurement Holding wire diameter: 8mm Dimension: 42.6mm 122.5mm 23mm Load capacity: 4 Installation: clamp type Output mode: lead output PARAMETERS Electrical parameters Ratio 1000: 1 or 2000:1 (customized) Accuracy class 0.1% Primary current 0 - 10A AC Secondary current 0 - 10mA AC (customized) Max. Cont. Input current 12 A Load capacity 4 Over voltage category CAT III 600V Output signal (AC current) From 0 to 10mA AC at nominal input current Output signal (AC voltage) From 0 to 100mV AC at nominal input current Frequency range 40Hz-2000Hz Dielectric strength 3KV 50Hz/60Hz at 1minute Temperature range -20C to +55C Output 2.5 meter cable with D01 connector Max. voltage not insulated conductors 600 V Standard EN 61010-1, EN 61010-2-032, IEC60044-1 Installation Clamp type Output mode Lead output(2.5m) Mechanical parameters Dimensions (L x W x H) (mm) 42.6x122.5x23 Weight (g) 250 Holding wire diameter (mm) 8 Max. jaw opening (mm) 8 Color Black Material PC+ABS+Polycarbonate, UL94 V0
INTRODUCTION: SPIKE SUPPRESSOR 1. Better temperature stability 2. Excellent impedance-frequency charcteristics 3. Outstanding resistance to unbalanced current 4. High saturation magnetic induction intensity-effectively reduce the size of common mode inductors APPLICATION: 1. Inverter circuit 2. Inverter� 3. UPS 4. Switching power supply 5. EMC filter inductor 6. New energy such as solar energy, wind energy
Application 1. Inverter circuit 2. Inverter 3. UPS 4. Switching power supply 5. EMC filter inductor 6. New energy such as solar energy, wind energy Magnetic amplifier switching power supply â?? Spike Suppressorï¼? 1. Better temperature stability 2. Excellent impedance-frequency characteristics 3. Outstanding resistance to unbalanced current 4.High saturation magnetic induction intensity - effectively reduce the size of common mode inductors
Model: Various Core Form: Epoxy core and plastic case Performance: accuracy class:0.5-0.1 Core material: Amorphous ribbon Package: Two different package for air and sea shipment Application: 1.Electric energy meters, power meters, ammeters, electrical measuring equipment and other instrumentation fields. 2.Various types of power current transformers in power transmission and distribution power monitoring systems. 3.Leakage protection, relay protection, servo motor protection, fire monitoring, etc. 4.Current and voltage data sampling, etc. Advantage: 1.High initial permeability. High product accuracy and small error (ratio difference and angular difference) 2.High saturation magnetic induction, wide detection current range. 3.Low coercivity, more stable product performance, more sensitive to weak current induction. 4.Good thermal stability. Small change in permeability and error thermal shock 5.High Curie temperature, excellent temperature characteristics. 6.Long-term working temperature:-50ï½?+130â??
Transducer.
SANDI SERIES charging module is for electric vehicle charging station. With single-phase non neutral conductor AC input, it has the advantages of high efficiency, high power density and low harmonic. Functional details 1. Hot plug Plug technology is applied to the charging module to provide convenience for installation and maintenance. The access of the charging module to the system shall not disturb the output voltage of the system. 2. Advanced current sharing technology Under constant voltage working mode, the charging modules can share current automatically within 10S, with degree of unbalance less than �±0.5A. 3. Control of input limited power Refer to Fig. 1-10 for the relation between the output power and input voltage of the charging module. When the input voltage is within 360 Vac ~ 450 Vac (return difference is less than 5V), the module can output the maximum power of 20 KW; when the input voltage is within 260 Vac ~ 320 Vac, the module can still work normally under limited power mode. 4. Control of output constant power When there is a rated input voltage, the output power of the module is 20 KW. Refer to Fig. 11 for the relation between the output voltage and the output current of the module. The SD75050 module uses two operating modes with output voltage ranges of 50 to 750V. The module only selects the operating mode based on the value of the received demand voltage, and does not select the operating mode based on the actual output voltage. 5. Temperature limited power 6. Regulation of output current limiting point 8. Regulation of output voltage The output voltage of the module can be regulated constantly through the external monitoring module, with regulation range of 50Vdc ~ 750Vdc and minimum regulation step of 0.1 Vdc. 9. Fan control The built-in processor of the module can regulate the speed of the fan according to the internal temperature and output current of the module. 10. Protection of input overvoltage/ voltage shortage 11. Output overvoltage protection The overvoltage protection point is 260Vdc ~770Vdc (�±10 Vdc). Default is 778Vdc.The module can be started after manual intervention upon overvoltage protection. 12. Over-temperature protection The environmental over-temperature protection point is 80�°C. When the DC panel has a temperature over 100�°C, the module will stop working; when the DC panel has a temperature below 90�°C, the module will automatically work again. 13. Protection of internal bus fault When the internal bus voltage of the module is beyond the overvoltage/ voltage shortage protection point, the module will be powered off automatically. At this time, there is no output from the module and the fault indicator light is on. 14. Short circuit protection In case of short circuit of the module, it will be subjected to protective shutdown and the red indicator light of the panel is on, and this condition will be transmitted to the monitor of the "module fault".
Ultrasonic transducer, ultrasonic cleaning generator, ultrasonic cleaner, ultrasonic immersible transducer and other ultrasonic cleaning parts..
Ultrasonic transducer.
Ultrasonic transducer.
Ultrasonic transducer.
Different capacity drying noodle making machine ,fresh noodle making machine long noodle making machine paste Italy noodle spaghetti making machine : Name Model & Parameters Qty set Note Automatic Hang Noodle Making Machine 5-260model, machine size 3*0.6*1.2m, voltage 380V,3KW, weight 440kg, capacity 150-200kg/h 1 Attached 3pcs cutter. 100 pcs hanging noodle poles Welcome order !
Fish seafood grading sorting weighting machine,Parameters Exclusion method Pneumatic swing arm Working height 800mm�?�±50mm working voltage AC220V 50HZ Total rated power of sorting machine 1kwhour Delivery direction Facing the operation interface from left to right working temperature From -20 C to 40 C Scale size 630MM (optional size according to the divided object) Shaving and discharging direction customization.
New designed fruit slice machine,can slice lemon,orange,apple,pear,kiwi ... same this kind oval and round fruit vegetable can process Parameters : External dimensions: 2800 * 1200 * 1250 mm Input voltage: 220 V Total power: 3 kw Production: 90-120 pcs/min Total weight: 340 kg Health fruit slice for people eating, good business ! welcome cooperate! contact us fruit slicer machine lemon slice machine
Mangoes juice machine fruit vegetable process machine fruit juicing machine This fruit juicing machine can process different vegetable fruit more kind as pictures show : when processing juice can put some water Capacity 300kg-1000kg/h voltage 380V/50Hz/1.5kw Mesh diameter 0.8 mm Spindle speedr 800 /pm Machine size 950 *800* 1200mm also have big capacity
Stick ice lollipop ice filling sealing machine The automatic stick ice filling -sealing machine for lollipop ice is small in size and light in weight, and is made of stainless steel. This machine can produce various beverages such as lollipop ice, milk sticks, fruit milk, fruit cold drinks, and so on. from small capacity to big capacity . Product parameters of one : Voltage: 220/50 (V/Hz) Power: 0.75KW Sealing speed: 2000 cups/hour Filling capacity 0-150ml Specification: 960 * 430 * 330mm (Welcome give thumbs-up, comment,transmit) welcome order !
Automatic cylinder turnover dough mixing machine for various kind bakery food /wheaten food and so on same this kind food , During operation, the hook and hopper rotate at the same time to make the dough more uniform, the bucket can be automatically turned over and removed, and the mixing head can be lifted, which is convenient for fetching and cleaning. It is equipped with a head up emergency stop device to ensure safe use. Castors/foot-wheel are installed at the bottom for easy movement. Mixing hook ,cylinder ,safety cover all by SUS material . Parameters : 50kg/ 75kg / 100kg / 125 kg/time power 7.75-14.25kw voltage 380v/50hz 1380 * 1160 *1400mm / 1580 *1380*1560 /1650 *1500 *1630 /1680*1550*1650mm Bread dough mixing machine How to making dough Delicious bread dough
Transducers.