This is chemical setting Furan based chemical resistant mortar which is combination of Liquid and Powder, when mixed in proper proportion from workable mortar which after setting and curing give of liquid and give black highly cross linked composites. Furan When set and cured is resistant to highly corrosive acids, alkalis and to powerful organic solvents such as ketones, Aromatic and Chlorinated solvents. It has extreme resistant to Acidic & alkalis, Salts, Greases and Detergents. It resists to Organic & Inorganic acids at their boiling temperature. It is suitable against mild chlorine Gas (dry) phosphorous trichloride, pyridine at room temperature. Furan is especially useful where resistance to mixed media such as aqueous acids /alkalis and organic solvents is needed in chemical plant process and waste streams. Carbon filled Furan is used against corrosive effect of hydrofluoric acid & its salts. PREPARATION OF FURANE MORTAR : Mortar consist of Furan solution and Furan powder. The average mixing ratio necessary to obtain mortar with good working consistency is 1 part by weight Solution & 3 part by weight powder. The ratio will vary slightly depending on temperature and working conditions.Stir the liquid thoroughly before using. Place liquid in a suitable shallow mixing pan. Add powder by weight in the solution mix thoroughly and rapidly until all lumps are dispersed and the mortar is completely homogenous. Spread out the mortar in a thin layer, not more than ¾ thick, to dissipate the heat of reaction and lengthen the working life. Batch size can be varied depending upon the temperature and the speed with which the masons are working. Very large batches will become stiff quite rapidly. Make sure that all the Furan Motrar is used from the pan before another batch is mixed.When working at temperature above 40 C, very small batches not more than 2 Kgs, should be prepared. When working at temperature below 15C the liquid should be kept warm.
Excavators.
suitable for Pressure Sensitive coating application in BOPP Packaging Tapes, Holographic labels and other allied uses.
suitable for Wet Lamination of films like BOPP, PVC etc. to Paper / Duplex Board.
Electronic hardware as well as construction materials and equipment..
suitable for paper bags handle
Construction, and minerals, sesame seeds, soybeans, groundnuts, grains and hibiscus flowers. granite slabs, ceramic tiles, as well as minerals like iron ore, lead ore, zinc, and beryllium among others..Sourcing high quality products, negotiating favorable terms with suppliers, managing logistics and shipping
Varnished laminates with paperboard (While using BOPP laminates, ensure the surface energy of the film should be minimum 38 dynes/sq. cm,). It can be used for paper bag side & bottom pasting
FILM TO PAPER (WINDOW MAKING IN ENVELOPS)
Dust
Silicone GP, Acrylic, Duct, FR
Stucco & Putty
AAC Block
Bitumen Sheet
Tile Grout
Liquid Water Proof
Rockwool
Tile Grout
Rockwool, also known as mineral wool, is an insulation material made from natural stone or mineral fibers. The density of Rockwool refers to the mass of the material per unit volume, and it is commonly expressed in kilograms per cubic meter (kg/m�³) or pounds per cubic foot (lb/ft�³). The density of Rockwool can vary depending on the specific product and its intended application. Common densities for Rockwool insulation products range from approximately 40 kg/m�³ (2.5 lb/ft�³) to 200 kg/m�³ (12.5 lb/ft�³) or more. The choice of density often depends on factors such as thermal performance requirements, structural support needs, and the specific application of the insulation.
We have all kinds plaster profiles like studs,tracks,omega,corner bead etc. with competitive prices.
